Hub flanges

[The Raider]

I made a fixture to produce the hub flanges. Sell or trade for other good stuff.


Price: $15.00 each
e-mail: jerry@jerryhey.com
phone: 260-709-4507

[Pagan Wizard]

Sounds cool Jerry. What are the dimentions of the flanges, or can they vary based on someones needs?

[The Raider]

The same measurements at the DW plans call for which is a 5/8" axle hole and over all diameter of 2.5 inches. I could easily change the axle hole to any size but the spoke circle is built into my fixture and it cannot be changed. I am going to try to post a pic but ran into problems with attachments earlier today. If you don't seen it, e-mail me (jerry@jerryhey.com) and I will send it to you direct. Jerry

[Radical Brad]

Nicely done.

Brad

[Pagan Wizard]

I assume this is the pic you had trouble posting?? I just use Photobucket for my pic posting.

http://i23.photobucket.com/albums/b392/Boomer7049/hubflange.jpg

They look great, when the time comes for me to start my build, I will definately look you up for some with a 3/4 inch axle.