Center pull brake?

[dynodon]

I think I'm going to buy a set of Diacomp center pull brakes for my LWB bent antone know where I can get the hardware that mounts the cable to the goose neck?

[ken will]

Is this what you are looking for?

http://www.nashbar.com/images/nashbar/products/large/NS-HTCS-NCL-TOP.jpg

http://www.nashbar.com/bikes/Product_10053_10052_175223_-1_201521_10000_201527

[dynodon]

I've found those too but what do you use in the rear?

[PeterT]

Attach it to your seat post, facing rearwards, or mount it on a some rubber sleeves to the bottom wheel stay, or the cross bar, where ever you need a centre pull cable run

PeterT

[dynodon]

pics I need pics.....

[PeterT]

Sorry Dynadon,

All the pics for this lil' item are inside my head, and I cant get the printer to connect! :jester:

However if you run your cable along your frame, you can very easily see where you need to have a centre pull cable, then all you have to do is measure the diameter of the post, and make a bracket to suit,or weld something in the spot.

I make my own cable pulls, simply by drilling a hole just bigger than the inner cable, and welding ta very small piece of metal in the correct posi. I actually have three cables using one stop, the holes are carefully measured so that each cable lines up flat next to each other.

PeterT

[Sparky]

how schwinn did it in '73 :D

looks to be a fairly simple stamped steel bracket. now, how to adapt that to a bent is another story.

http://i14.photobucket.com/albums/a318/sparky96181/jeep/rearcenterpull010.jpg