DIY Bike and Trike Plans



  • Building a Front Wheel Drive recumbent lowracer - England

    http://4.bp.blogspot.com/-dnI1OQUZ4N.../s1600/ian.jpg
    Ian W. Swindells (forum member swizz69) always wanted a recumbent bicycle. Researching online brought him to the AtomicZombie builders forum. After learning about the Warrior Tadpole Trike, Swindells was motivated to design and build a Front Wheel Drive recumbent lowracer. In a feature article for the AZ newsletter, Swindells discusses the project and the challenges along the way. Read his story>>
    Comments 3 Comments
    1. The Cat's Avatar
      The Cat -
      Have you seen the pedal-powered Escargot boat that could be used as a narrow canal boat? Think it is from an American boat builder. I may have copied the article sometime last year or the year before this would be a project a family could tackle. Over the weekend I may have a change to look for the article and post on forum.
    1. jrich's Avatar
      jrich -
      Did the turning wheel cause trouble with the drive chain and the chain bending?
    1. darnthedog's Avatar
      darnthedog -
      Quote Originally Posted by jrich View Post
      Did the turning wheel cause trouble with the drive chain and the chain bending?
      This article was frolm 2 years ago and you may not get a responce. Plus it was an article not a posting so it may not have been a member of the site. Just an FYI
  • Recent Forum Posts

    Toyguru

    Re: Pics of my Warrior

    Looks awesome!
    Did you make the seat too, or purchase?

    Toyguru Yesterday, 10:57 PM Go to last post
    MrIdaho

    Re: Delta fox electrified

    Well I am bad, should be banned from AZ as I am working on wiring my street fox with a mid drive motor, the camera is IN THE shop but have yet to take

    MrIdaho Yesterday, 07:36 PM Go to last post
    willym

    Re: Winnipeg Warrior

    Thanks Hugh.

    willym 09-23-2017, 08:32 PM Go to last post
    Hugh

    Re: Winnipeg Warrior

    Willym the heel straps were easy to make. Make a paper template to get an idea for the bends of the aluminum arms. Then drill a few small holes so the

    Hugh 09-23-2017, 11:19 AM Go to last post
  • AZTV videos

    bike building tutorials

    More AZTV videos here.