hi all

Does anyone know an easy way of fixing BB7 caliper mounts ?

So why my difficulty ? the worlds most popular Disc Brake ???

First off the supplied discs are not round , so I assume if I fit them to one of the flat sections there may not be clearance at the corners ?



Secondly the pads within the rotor seem to be at an angle to the caliper and not at right angles to a line through the wheel axle out to the caliper ?


If you imagine lines parallel to the bottom of this picture through the mount holes , the pads are oblong and follow the angle writing seen below the red adjuster.

I may have to make a 14mm hub only that I can bolt the rotor to and be able to get my head close enough to see what is happening as the wheel is currently in the way

Answers on a post card please ?