Recent content by Jesper

We call it "pinnsvets" so I translated it to Swenglish, something which readers will see more of. English is my forth language. I remember once I translated charger as "loader" as it is called "laddare" in Swedish. The weather is bad for now, so it is not possible to do much untill it...

I think I will make the hubs, in the plans or if I can use the old, remove stuff and weld the axle in the larger hole. The bearings will then be on the axle.

I may get a new grinder, can't find that I used before. I have some tools, but they are for woodworking. I have no welder, but that could be bought. The only place I can weld safe it outside, and a welder with gas may be difficult (windy). A pin welder I think is a bit difficult as I have to...

I have just start to study the plans, and my first impression, they are very good. I have to get used to imperal and make translation to metric, I did a ruff and fast program, to help, as I am not good to see thats a foot or an inch is in metrics. My plan is to get a 4-wheeler side by side...

Yes I have seen all his videos, and got a lot of learning. A 4 wheeler frame is not the most difficult(strong enough and not too heavy), it is the way to make the drive, and steering working well.

snipped Yes a trike like Kyoto would be easier to build than a 4-wheeler, but my whife has worries a trike will tip in corners. It is not the same problem with a cycle as with a factory made car, regarding spareparts, as there are many brands out there which is used by many or near all who...

Hello! This is my first post here. I have currently an electric car, which belongs to a moped class, and has a speed of 45km/h. The problem is the importer went out of business, and the factory in China do not support the model anymore. The car is still running, and is not a bad car, but in the...