Thinking of adding some type of Plate/gusset from the down tube to the rear wheel frame, reinforce that section.Can you upload the full size image rather than the thumbnail?
Mine isn't e assist, but pushed hard to get up the hill.if that is e-assist then the e-bit pulls the drive-side of the chain so hard it breaks the welds by trying to fold the trike in half.
That's the best way. Perhaps two gussets, one top and one bottom. Cut them from the same size box as the frame so it's the same width and then weld all round.Thinking of adding some type of Plate/gusset from the down tube to the rear wheel frame, reinforce that section.
I bought it from the guy that built it, not sure of his building skills, will weld it and reinforce it, it looks like a point that could be weak, have wondered about it in the past.It's possible the weldment wasn't that strong. Re-weld it.
Same.I just see a no entry sign in grey.
Well your lucky I don't even see that !Same.