Latest Activity

I was thinking since 'off-grid living', yard/farm and related stuff keeps getting more popular, why not some of this idea in build...

I wouldn't expect any handling issues from such a swap. Do remember though that that extra 2" radius may put the rear of the wheel...

The angle of the head tube/forks is the most important part of handling. 24 should be fine. Not sure what effect front suspension will...

Hello all - I am new to this forum! I have begun to build a timber-wolf trike. I know very little about bicycles and handling...

Would not do it this way again ! much to much inaccurate flap disc work , I think the bolt is a few degrees out looking from above...

Smashing Stuff Paul. It is coming on a treat. Lots of articulation from that ball-joint. :)

I have always thought that tidying the shack is a complete waste of time. Things end up in places that you are not used to (read: can't...

Ok so lower frame member welded up ? This is underneath one plate welded to end of square tubing next welds along are a ring going...

Good shout Paul, it looks right doesn't it?

need a measurement ? centre of elastomer to centre of vertical rod end bearing. So blew Flevo Trike drawing up till tubing was 1.5"...

Those are from icletta. I have let them spoke by a bmx shop near me, but they also sell them build. Axle is 12mm. Strong enough and...

When you say 220kg under what circumstances ? compression ? bending ? other ? Paul

Hi Paul A 50 x 45mm rubber bush can handle about 220kg. It's a trial and error situation, and if no good, estimate a replacement based...

Ok it should look like this ? Lower portion in red is outline of lower frame tube [ bolts at either end are just supports ] You can...

Where can I purchase two front wheels like these? 20" 6 bolt on disc with 15/16" or 1/2" axle?